8
6.
Reinstall the hanger ball on the downrod as follows.
Route the wires through the hanger ball. Position the
pin through the two holes in the downrod and align
the hanger ball so the pin is captured in the groove in
the top of the hanger ball. Pull the hanger ball up tight
against the pin. Securely tighten the set screw in the
hanger ball. A loose set screw could create fan
wobble. (Figure 6)
Figure 6
7.
Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 7)
5.
Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 5)
Hanger Bracket
Figure 7
Ceiling Canopy
Canopy Screw
Cover
Motor Coupling
Cover
How to Assemble Your Ceiling Fan (Continued)
CAUTION
All set screws must be checked, and retightened
where necessary before installation.
Figure 5