F&U DMV9783KUC, Инструкция по эксплуатации

Страница: 18 / 32

16
Press the main power button on the unit or on the remote control. Switch on the television, as
well as the amplifier(if connected)
Select the correct setting on the television(AV1,AV2,S-Video, DVD,etc). If an amplifier is
connected, select the corresponding output setting on that unit.
Press Open/close on the remote control or on the front panel of the main unit to open the tray.
Load a disc (label side up) onto the tray and press Open/close again.
The unit will take a few seconds to load the disc’s initial data, display the disc type logo in the
upper left corner of the television screen and then start automatic playback.
Note:
MP3 discs usually take a little longer to load than video or music discs.
If a DVD disc menu appears on screen:
the Play button on the remote control or on the unit to start playback,
or use the directional keys to select the desired menu option, and press Enter to confirm.
Error messages and possible solutions.
Wrong regional disc
The loaded disc’s regional code does not match the player’s regional code.
Wrong password
The rating level of the loaded disc is higher than the rating level set for the player. The player will
not play the disc until the correct password is provided.
Wrong disc
The player has automatic disc quality detection software installed. When the player detects a
damaged disc, it will automatically play the encoded data at a lower level or not play the
disc at all, depending on level of damage.
Note:
The production quality of discs vary. Some incorrectly formatted discs may load, but the
quality of the audio and video produced may be of a lower quality.
If the player is not used for an extended period, please unplug the power plug.
Switch on the player
System setup
Loading a disc
Automatic playback
Disc error messages
Power management