SAFETY PRECAUTIONS
4
Rev 6.0
Fanco Infinity DC. All Rights Reserved.
6.
The hanger bracket must be firmly screwed to a load bearing building structure e.g. a concrete
ceiling, steel structure, or a timber frame. If additional timber frames are to be added, those must
be securely nailed or screwed between the beams.
7.
Attach fan blades after the fan motor housing is installed and properly secured. Keep the fan
motor and blades in the original package until it is ready to be installed.
8.
Check and confirm, after the fan is completely installed, that all connections are proper and
secure to prevent the fan from falling or causing property damages or personal injury.
9.
Take care not to bend or damage the motor Drive Shaft or Fan Blades when handling or installing
them. If such defect is noticed, please contact the Customer Service before installation of the
ceiling fan.
10.
Both the fan and the hanging bracket must be earthed.
11.
Do not remove the fan from the ceiling after installation.
12.
Make sure electricity is turned off at the main power box before commencing work. Turn off the
power by removing fuse or turning off circuit breaker before installing the fan.
ELECTRICIANS AND INSTALLERS NOTICES
1.
The
AUSTRALIAN CONSUMER LAW ACT 2010
mandates consumer protection against defects
or poor workmanship in provision of services (such as installing a ceiling fan). To protect
yourself and the consumer, these instructions must be followed. Failure to do so may result in
the consumer making claim against you for consequential loss or damage.
2.
If there are any problems with the products at the time of installation, the installer must contact
the Customer Care Hotline (located on the Warranty Card)
BEFORE
leaving the job site.
3.
Do not remove the fan from the ceiling once installed, unless instructed to do so.
CLEARANCES AND ANGLED CEILING
*Fan shown are for illustration purposes only. Actual product may vary.
(Minimum
)
2.1m
(Minimum)
>1.5m
19
˚ (max)
Floor level
(Recommended)
1.5m
(Recommended)
1.0m
Raked Ceiling
