REMOTE PAIRING INSTRUCTIONS
10
Rev 6.0
Fanco Infinity DC. All Rights Reserved.
NOTES:
I.
After the AC power is ON, do not press any other button on the transmitter before pressing the
“STOP”
& “LIGHT OFF”
buttons as doing so will cause the procedure to fail. After completing the
steps above, you should be able to operate the ceiling fan. If the fan is not responding to the
transmitter, please turn the power off to the receiver and repeat all the steps again.
II.
When performing code learning, ensure that the distance from receiver to transmitter does not
exceed the range of 10 metres.
III.
If you find your transmitter
controlling more than 1 fan, this means that the other “fan” in the
nearby location has pick up the same ID code. This is not a fault. Make sure only fan that needs
to perform ID code learning are power ON, and the rest of nearby fans are power OFF. See
above instructions on how to control independent or multiple fans.
IV.
Check that battery is properly installed.
V.
Remove the battery if not used for long period of time to prevent damage to the hand held
remote.
