Fanco Horizon DC CFFCHZ23BLSMR, Руководство по установке

Страница: 16 / 20

CARE & CLEANING:
• Periodic cleaning (approximately 6 months) of your ceiling fan is the only maintenance
required.
• Use a soft brush or lint free cloth to avoid scratching the finish. Please turn off electricity
when you do so.
• Do not use water when cleaning your ceiling fan. It could damage the motor or the wooden
blades and create the possibility of an electrical shock.
• The motor has a permanently lubricated ball bearing and as such, is maintenance free.
NOISE:
The manufacturer warranty covers actual faults that may develop, but NOT minor
complaints, e.g. motor operation noise - ALL ELECTRIC MOTORS ARE AUDIBLE TO SOME
EXTENT; this is more obvious when the fan is operating at low speeds.
WOBBLE:
• Ceiling fans are designed to move during operation because they are not generally rigidly
mounted
• Movement of a couple of centimetres is acceptable for safe operation.
• Balancing kits included should be used to adjust the balancing when first installed.
NORMAL WEAR AND TEAR:
Threaded components working slighting loose or blade carriers even slightly bent due to
vigorous cleaning or bumping can cause extra wobble and noise. THIS IS NOT COVERED
UNDER WARRANTY, but a little care and maintenance can reduce or prevent this problem.
REMOTE CONTROL SETTINGS & OPERATION
REVERSE FUNCTION
The “Summer/Winter” reverse function is included in the remote control to make the fan
rotate in an anti-clockwise direction during summer.
In winter, this can be reversed, so that the blades now move in a clockwise direction.
Press and hold “F/R” button for 3 seconds to switch between “Summer” and “Winter modes.
NOTE:
The Hand Held Remote Control System is equipped with a learning frequency function
which has code combinations to prevent potential interference from other remote units. The
frequency on your Receiver and Transmitter units have been pre-set at the factory. If the
remotes need programming please following these instructions and use a small size tool to
change the code switch setting for each remote.
PAIRING THE REMOTE:
1. Connect power to the fan.
2. Within 10 seconds after turning on the power, short press “ON/OFF” 3 times, followed by
the 4th press and hold the button for 3 seconds. Then, the fan will beep once and it means
it’s paired successfully.
3. Now test the remote by pressing on speeds or light button.
4. It can take up to 10 seconds for the fan to start moving, after pressing a speed button.
The fan may move a few times slightly backwards and forwards and then will start rotating
slowly whilst building up to the correct speed. This is normal behaviour for DC fans.
Considerations:
1. If the receiver is not receiving a signal from the remote control:
a. Please check the battery to ensure it has sufficient power and has been inserted correctly
and aligns with the positive and negative terminals; or
b. Please check if there are any other similarly remote-controlled objects that work nearby,
as remote-controlled items operating on the same frequency may disturb each other.
15