IMPORTANT: ENSURE ALL CABLES ARE ELECTRICALLY ISOLATED BEFORE WIRING.
1) Wire the incoming power cables to the terminal block mounted on the hanging bracket.
Wire Active, Neutral and Earth to the corresponding FA, N,
terminals respectively.
2) The remote receiver has been pre-wired to the hanging bracket. Do not remove. Connect
the quick-connect plugs between the remote reciever and the motor (see above image).
Note: The Model with light has two plugs. The model without light has one plug.
3) Slide the Remote Receiver unit inside the hanging bracket and carefully position all excess
cable inside the boundaries of the hanging bracket.
4) Slide the canopy up to cover the ball joint, wiring, receiver unit and hanging bracket, then
secure in place.
5) Power up the fan.
6) Install the battery into the remote control and operate the fan blade speed and light with
the handheld remote control unit.
7) Note: If more than one fan and remote is to be installed, then program each fan individually
with only the fan to be programmed powered on. The other fan must be disconnected from
the power.
ELECTRICAL WIRING
This fan must be installed by licenced electrician.
For your convenience, and to assist in easy installation & cleaning, your ceiling fan is
connected with easy connectors.
View after installation
