Fanaway LED EVO1 Installation Instructions
8 |
P a g e
V e r 1 . 0
USING YOUR CEILING FAN
FAN WALL CONTROL
Turn on the power and check the operation of the fan.
• OFF Position – fan off
• 3rd Position – low fan speed
• 2nd Position – medium fan speed
• 1st Position – high fan speed
Light Control
• Toggle switch – on/off
Using LED fitting with dimmer (not included)
WARNING:
FOR YOUR SAFETY ALL ELECTRICAL CONNECTIONS MUST BE UNDERTAKEN BY A LICENSED
ELECTRICIAN.
DO NOT use a remote control which has a dimming function to control this LED fitting.
This LED light kit is dimmable and has been tested with Clipsal 32E450TM, 32E450UDM and LUCCI SKU# 290998
dimmers only. The use of non-recommended dimmers will void warranty and may damage your LED light fitting.
NOTE:
For use with LUCCI SKU# 290998 trailing edge dimmer, the best dimming performance is achieved by
adjusting the variable resistor at the minimum and maximum dimming position on this dimmer during the install.
NOTE:
Dimming may cause buzzing sounds or a slight flicker. Slight delays with the lamp starting up and slight
uneven light performance can occur when more than one LED light fitting is linked together, switched ON and dimmed.
This is not a product fault and as such is not covered under warranty.
NOTE:
Some dimmers have a minimum load of 20W. Before turning on the LED downlight, ensure the dimmer
position is on the maximum setting.
NOTE:
A licensed electrician is required to hardwire/install a local dimmer/switch to the LED light fitting.
Reverse function
Your ceiling fan can operate either in fan mode or reverse fan mode.
SUMMER Mode: The reverse switch shall be in the
“LEFT” (SUMMER) position to make the fan rotate in an
anticlockwise direction. The airflow will be directed downwards, for cooling in summer.
WINTER Mode: The reverse switch shall be in the
“RIGHT” (WINTER) position to make the fan rotate in a clockwise
direction. The airflow will be directed upwards, for energy conservation in winter.
Fig. 10
