Fanaway LED EVO1 Installation Instructions
5 |
P a g e
V e r 1 . 0
ANGLED CEILING INSTALLATION
This fan hanging system supports a maximum 15 degree angled ceiling installation.
HANGING THE FAN
Installing the down rod
1)
Feed the down rod (5) through the canopy (4) and the bolt and pin cover (6).
2)
Remove the ball joint by loosening the set screw (3) and insert the motor wires through the down rod and then
secure the ball joint back to the down rod.
3)
Insert the down rod to the coupling (7), line up the coupling holes with the down rod holes and insert the bolt (8).
Then insert the pin (9) to the end of the bolt.
4)
Finally secure the down rod and coupling by tightening the two set screws (10) on the coupling. Fig. 4
5)
Lift the fan assembly onto the mounting bracket (1). Fig. 5
6)
Make sure the tab (2) on the mounting bracket socket is properly seated in the groove (3) in the ball joint. Fig. 5
LIGHT KIT INSTALLATION
1)
Loosen the screw (1) from the base bracket (3). Align the two slot screws (2) with the keyhole slots of the lamp base
(4). Fig.6
2)
Turn the lamp base counterclockwise until the slot screws are firmly at the end of the slots.
3)
Secure screw 1 back to the base bracket. Tighten all three screws. Do not over-tighten.
4)
Connect the upper plug (1) from the driver to the lower socket (1) in the LED board (3). Fig.7
Fig. 3
Fig. 4
Fig. 5
