Fanaway LED EVO1 Installation Instructions
8 |
P a g e
-
The remote (transmitter) and receiver must be configured so that communication between each other is
paired up. This is achieved by setting the DIP switch on the receiver and remote on the same setting.
Note: The DIP switch assembly has 4 switches which can be setup to 16 different transmitting code
combinations. This is practical when there is more than 1 remote/receiver pair operating locally or in the
same room.
Note: To access the receiver DIP switches, remove the DIP switch cover.
Fig. 8 Remote battery compartment Fig. 9 Receiver DIP switch
OPERATING THE REMOTE:
Before you start using the remote, take the time to read through this section and
get familiar with the buttons and function of each button.
1.
LED Indicator
The red LED indicator on the top of the transmitter will flash when the buttons are
active.
BUTTONS ON THE REMOTE
2.
HI:
Press this button to set the fan running at High speed.
3.
MED:
Press this button to set the fan running at Medium speed.
4.
LOW:
Press this button to set the fan running at Low speed.
5.
OFF:
Press this button to turn OFF the fan.
6.
:
Press this button to change the color temperature in the following order:
3000K
→
5000K
→
4000K
→
3000K
7.
:
Press this button to turn ON/OFF the light and press and hold the button to access the light dimming
function.
The remote has memory function. If the fan or light is turned off by the isolating switch, it will memorise and
recover the last status when turned on next.
Fig. 10
