Standby Power Indicator
Light up when power connected,
When the power button on, the “On”lights up,
and this indicator light turns down.
Power Button
“I”,power on
“O”,power off
Handle
“ON”,Power Indicator
When it is green, the main power system works, or not work.
Mounting hole
Standard 19" Frame, 2U
Vent hole
Inner installed fan sucks air and flow to rear panel;
If the power amplifier works over-load,
the fan will rotate speedily, do not block the vent hole.
Front Panel Function Introduction
CLIP lights up
It shows that the distortion happens, about 0.5% distortion.
PROT lights up
It shows that the protection function works; it lights up when
short circuit, direct current, over heat, VHF(long time whistle)
Ch
Ch
2 volume knob
When in bridge mode, this knob doesn’t work,
the volume is controlled by CH1.
When in stereo or parallel mode, this knob can
only control the volume of
2.
Gain control range -80~0dB.
Ch1 volume knob
When in bridge mode, this knob doesn’t work, the volume is controlled by CH2.
When in stereo or parallel mode, this knob can only control the volume of CH1.
Gain control range -80~0dB.
10dB Signal Indicator, green
Signal Indicator, green. Bridge mode Indicator, orange
Parallel mode Indicator, orange
PEQ control box
5dB Signal Indicator, orange
Rated power rates are displayed in the
“Specification”page.
CH1
CH2 PEQ PCB indicator
When insert the PEQ PCB, the green
light will light up or off with the power on or off.
，
,
Masx series power amplifier
P5
MAsx
