FALMEC DIAMANTE Скачать руководство пользователя страница 17

Страница: 17 / 64

Button -

By pressing the key the motor speed reduces.
Speed 1, 2 and 3 is displayed by the number of LEDs switched on, excluding the light and
timer LEDs.

By pressing the key the motor speed increases.
Speed 1, 2 and 3 is displayed by the number of LEDs switched on, excluding the light and
timer LEDs.
(In the 4 speed version the + key shows an intermittent light. The 4th speed or intensive
setting is timed and after about 7 minutes the motor automatically switches to 3rd speed).

Mode button

Function: cookerhood motor switch-off and switch-on.
The

desired speed

function enables starting the motor with the last speed selected prior

to switch-off.

Filters saturation and timer button

• This function enables the automatic switch-off of the cookerhood after 15 minutes of func-
tioning at previously set speed (button with intermittent light).
• After about 30 hours of operation, the button reminds you to wash the metallic filters (red
lit button). To deactivate the alarm, press the timer button for a few seconds until the red
light switches off. Subsequently switch-off the cookerhood and switch it on again to verify
the cancellation of the alarm.
Note: in the Diamante hood the filter saturation report function is not active.

Note for Diamante hood:
The Diamante hood is already equipped with a radio receiver for radio control. The radio
control is available for purchase as an optional. To use the radio control on the hood com-
plete the following learning procedure:
press the push button control panel timer button for 2 seconds and when the red led of the
push button control panel turns on press any button on the radio control within 10 seconds.
This operation records a new transmission code.

WARNING (version with radio control):

Place the device far from sources of electromagnetic waves which could interfere with the
hood electronic functions.
Maximum operating distance 5 metres. This distance may vary in defect based on the elec-
tromagnetic interference of other devices.
Remote control light button: light on/off.
Speed increase/de and - button ( to start the motor press

either key + or key -.

INSTRUCTIONS FOR RADIO CONTROL CODE CHANGE
(to be used only in case of malfunction)
Disconnect the appliance from the electric power supply mains.
To enter into the code change mode press the “Luce” (Light) key together with the “Timer”
key (of the radio control) for more than 3 seconds, until the LED begins to slowly flash.
If the “-” key (of the radio control) is pressed within 5 seconds, the random new code will
be generated and memorised in the radio control. Memorisation is confirmed by three short
flashes of the LED.
To return to the default code: press the “-” and “+” keys of the radio control together for over
5 seconds. After 5 seconds the remote control memorises the default code. Memorisation
is confirmed by three short flashes of the LED. Connect the appliance to the electric supply
mains and ensure that the lights and the motors are off.
Press the push button control panel timer button for 2 seconds and when the red led of the

English