Battery Replacement Guideline
1.
Per the picture below detailing the SG2K-1T rear panel, remove the battery fuse.
2.
Per the picture below remove the four screws securing the UPS top cover to the rear
panel.
3.
Per the picture below, turn the UPS so the right side of the UPS is facing you.
4.
Remove the two screws securing the UPS top cover to the side of the UPS
chassis.
5.
Turn the UPS
so the left side of the UPS is facing you.
6.
Remove the two screws securing the UPS top cover to the side of the UPS
chassis.
7.
Carefully slide the top cover off toward the rear panel direction. Take care to ensure
the top cover does not short on any of the internal UPS electronics when removing.
Screw # 1 securing the
top cover to the rear
panel
Screw # 2 securing the
top cover to the rear
panel
UPS Battery fuse
2 screws securing the
top cover to the bottom
of the UPS chassis
(typical)
3
Screw # 4 securing the
top cover to the rear
panel
Screw # 3 securing the
top cover to the rear
panel
