d.
Connect the UPS input power cord to the UPS inlet
located on the UPS rear panel.
e.
Verify the UPS output voltage Dip Switch setting match
your local utility voltage. Refer to the SG Owner’s Manual
for details.
f.
Connect the UPS input plug to a nearby grounded
receptacle. NEVER USE AN EXTENSION CORD.
g.
Connect the input power plugs for the equipment you want
to switch on and off to the UPS outlets 1 & 2 only. These
outlets are battery backed up.
h.
Connect the input power plugs for the equipment you want
on all of the time to the non-switched UPS outlet 3. This
outlet is battery backed up.
I.
UPS OUTLET 4 (BOTTOM OUTLET for SG1K-2T),
(OUTLET TO THE RIGHT FOR SG1KRM-2T) IS
RESERVED FOR CONNECTING THE SENSAPHONE
INPUT PLUG. THE SENSAPHONE INPUT PLUG MUST
BE CONNECTED TO THIS OUTLET.
j.
READ THE SENSAPHONE OWNER’S AND X10
MANUALS BEFORE GOING ANY FURTHER.