*030388-000-70*
030388-000-70
© Allegion 2014
Printed in U.S.A.
030388-000-70 Rev. 10/14-d
Customer Service
1-877-671-7011
www.allegion.com/us
Mounting and Rehanding
Installation Instructions
RW Series
Retrofit Lever Trim
STEP ONE:
Remove all existing trim from door,
including cylinder if one is installed.
STEP TWO:
Insert inner and outer spindles into lock hubs.
NOTE: Because of various hub sizes, be sure
spindles fit properly.
Place the enclosed template
over the spindle. Align with door edge and mark the
four (4) thru-bolt hole locations. This should be done
to both sides of the door. Drill the four (4) holes
halfway through from each side of door.
IMPORTANT: It may be necessary to enlarge the
trim hole due to varying door preps. Falcon retrofit
trim requires both sides to be 1
¹⁄₈
” diameter
minimum to clear trim mechanism.
STEP THREE: Before mounting the trim, be
sure to insert spindle springs into each
lever. With spindle in outer hub, place outer
trim over spindle with posts going into thru-
holes. Place inside trim over spindle and
install the four (4) mounting screws. Before
screws are tightened, check to see that
both levers are operating properly. If
reinstalling the cylinder, determine if a
blocking ring is required. Tighten set screw
then check cylinder for proper function.
Tighten the four (4) trim mounting screws.
REPLACEMENT PARTS
Spindle
Spindle
Adapter
Spring
P/N 021242–001–30
P/N 030329–000–30
P/N 030319–000–30
P/N 021244–001–60
5/16”
9/32”
5/16”
5/16”
3/8”
SPINDLE
TEMPLATE
SCREW
6-32x1
¹⁄₄
”
INSIDE
SPRING
SPINDLE
SPRING
OUTSIDE
TRIM HOLE
