INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
26
ArtNo.325-0002 - BI oven removing the door
Fig.7-6
Fig.7-7
ArtNo.281-0138 - Drawer pulled out
Fig.7-3
Fig.7-4
ArtNo.062-0001 - 90 Prof+ FX - Removing the door
Fig.7-5
Now:
1.
Remove the storage drawer
2.
Remove the oven door
3.
Lower the two rear rollers
Removing the Storage Drawer
Pull the drawer out to its furthest point (Fig.7-3).
Push the ends of the plastic clips – down of the left-hand side,
up on the right-hand side – to release the catches holding the
drawer to the side rails (Fig.7-4). At the same time pull the
drawer forwards and away from the side rails.
For safety’s sake push the drawer runners back out of the
way. Put the drawer somewhere safe – do not refit it until the
installation is complete.
Removing the Oven Door
To remove the oven door, open the door fully. Swivel the
locking ‘U’ clips forward to the locking position (Fig.7-5). Grip
the sides of the door, lift upwards and then slide the door
forwards (Fig.7-6).
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting nut
(Fig.7-7).
Rotate the nut – clockwise to raise – anti-clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the cardboard base tray. Grip the
fascia panel and lift the front of the cooker slightly.
Carefully push the cooker backwards off the base. Remove
the pack base. Position the cooker close to its final position,
leaving just enough space to get behind it.
n
n
DO NOT use the control knobs to manoeuvre the
cooker.
Refitting the Oven Door
To refit the door, slide the hinges back into their slots. Rotate
the locking ‘U’ clips back to fit onto the hinges.
