Main burner button
Pilot button
Piezo igniter button
Off button
Sightglass
Handwheel (G2962 only)
Change-over switch
(G2965 only)
Thermostat
Drop down door
Tilt switch (G2965 only)
Sightglass
Handwheel
(G2994 only)
Change-over switch
(G2995 only)
Thermostat
Drop down door
Tilt switch
(G2995 only)
Red indicator
Amber indicator
Thermostat
Control (off position)
SECTION 1 - GENERALDESCRIPTION
The bratt pans are thermostatically controlled to
maintain desired temperatures. Safety features
include a flame-failure cut-off device and a high
temperature limit device tocut off gas tomain burner
if pan temperature goes too high. A tilt-switch to shut
off gas to main burner if pan is moved even slightly
from fully lowered position is also fiited as standard.
A red light indicates electricity supply toappliance is
on. This is required to operate the controls.
The pan is made of cast-iron to retain an even
temperature.
On G2962/G2994 models, the pan tilting mechanism
is operated by the front handwheel. The handle can
be stored away when not in use by pulling away from
wheel and folding in toward centre.
On G2965/G2995 models, the tilting mechanism is
operated by foot bellows which in turn activates an
electric actuator. The bellows can be folded away
when not in use.
G2962/G2965
G2994/G2995
Figure 1
Controls
The unit is fitted with the following:
Mains Indicator Lamp (RED)
This is located on control panel. The red neon will
glow continuously when mains electricity has been
switched on and current is being supplied to unit.
Indicator Lamp (AMBER)
Located on control panel next to red neon. The amber
neon will glow continuously when user thermostat has
been set and heat is being supplied topan. Neon will
goout when selected temperature has been reached
and heat cut back. Thermostat will cycle on and off to
maintain temperature. This indicated by neon going
on and off.
Multi-Functional Gas Control
This is located behind bottom front drop-down door
and combines burner ON and OFF push buttons,
flame failure device and gas governor.
The push buttons are identified by their symbols
(see Figure 2 below).
Figure 2
Piezo Unit
This is located alongside multi-functional control
behind bottom front drop-down door and is a push
button piezo spark type which does not require a
battery (see Figure 2).
User's Thermostat
This is located on front control panel and has a
variable temperature range up to190
o
C when
medium depth frying (see Figure 3).
Figure 3
High Temperature Limit Device
This is factory pre-set and is not accessible to
operator. In event of user thermostat failure,
the high temperature limit device will shut-off gas to
both main and pilot burners.
Should this device operate and therefore, render the
unit unusable. The appliance should be serviced by a
qualified engineer.
