CARE AND CLEANING OF YOUR DUAL ZONE WINE STORAGE UNIT
Condenser
The condenser tubing inside the cabinet does not require
frequent cleaning; however, satisfactory cooling depends
on adequate ventilation over the coils. Be sure that noth-
ing obstructs the required air flow openings in front of the
cabinet. At least once or twice a year, brush or vacuum lint
and dirt from the condenser for efficient performance by
unscrewing the grille on the bottom front of the cabinet.
Cabinet
The painted cabinet can be washed with a mild soap and
water and thoroughly rinsed with clear water. NEVER use
abrasive scouring cleaners.
Interior
Wash interior compartment with mild soap and water. Do
NOT use an abrasive cleaner, solvent, polish cleaner or
undiluted detergent.
Roll-out Racks
The racks may be cleaned with mild soap and water and a
soft cloth. DO NOT use any abrasive cleaners.
Door Gasket
The vinyl gasket may be cleaned with mild soap and water,
a baking soda solution or a mild scouring powder.
Light Bulb Replacement
WARNING! DISCONNECT THE POWER CORD BEFORE
ATTEMPTING LIGHT BULB REPLACEMENT. Failure to do so
may result in an electrical shock that could severely injure
you.
This product uses two, 6 watt light tubes to illuminate the
interior of the dual zone wine storage unit: one in the
upper compartment and one in the lower compartment.
The upper compartment light tube is located behind the
display housing. The lower compartment light tube is
located on the underside of the divider that separates the
compartments. The light tube is a very reliable electrical
component, but should it not function properly, please call
the dealer you purchased your dual zone wine storage unit
from for a replacement light tube. Use only an original
equipment light tube from your dealer or from Falcon.
Do NOT under any circumstance use a light tube that
exceeds 10 watts!
To replace the light tube, disconnect power to the unit.
Use a hex-head driver to remove the two hex-head screws
holding the old light tube in place. Disconnect the electri-
cal plug from the cabinet’s electrical receptacle and discard
the old light tube. Reconnect the electrical plug of the new
light tube to the cabinet’s electrical receptacle. Make sure
it is secure and fully installed.
Using the hex-head driver, resecure the two hex-head
screws to secure the light tube in place. Plug the unit into
the electrical socket. Check to see if the light tube operates
properly. Your light tube’s replacement is complete.
The light tubes are not covered by your warranty. Replace-
ment tubes can be obtained from your dealer or from
Falcon.
In the Event of a Power Failure
If a power failure occurs, try to correct it as soon as pos-
sible. Minimize the number of door openings while the
power is off so as not to adversely affect the unit’s tem-
perature.
Disposal
When you dispose of this product, do so in a way sympa-
thetic to the environment. For further information, contact
your local authority.
5
Содержание FDZ60
Страница 10: ...NOTES...
Страница 11: ...NOTES...
