13
English
ArtNo.320-0002a Proplus oven door side screws
Fig.4-2
Once you have removed as much as possible with the scraper,
follow the
‘Daily Care’
procedure outlined above.
Grill
The grill pan and grid should be washed in hot soapy water.
After grilling meats or any foods that soil, leave to soak for a
few minutes immediately after use. Stubborn particles may
be removed from the grid using a nylon brush. Alternatively,
the grill pan can be washed in a dishwasher.
Before you remove any of the grill parts for cleaning,
ensure that they are cool, or use oven gloves.
DO NOT use any abrasive substances.
Control Panel and Doors
Avoid using any abrasive cleaners, including cream cleaners,
on brushed stainless steel surfaces. For best results, use a
liquid detergent or our Multi-purpose Cleaner.
The same cleaner can also be used on the doors. Alternatively,
use a soft cloth wrung out in clean hot soapy water. You can
use the same method for cleaning the control panel and
knobs (although we do supply a specialist Fascia Cleaner).
After cleaning, polish with a dry cloth.
Ovens
The oven door front panels can be taken off so that the glass
panels can be cleaned. Move the cooker forward to gain
access to the sides (see the
‘Moving the Cooker’
section under
‘Installation’
).
Door Panel
Open the oven door slightly and remove the front panel
fixing screws from the door sides, two each side
(Fig.4-2)
.
Carefully lift off the outer door panel. The inside face of the
glass panels can now be cleaned – take care not to disturb or
wet the door insulation.
After cleaning, carefully refit the outer door panel and replace
the side fixing screws.
‘Cook & Clean’ Panels
The main oven has side ‘Cook & Clean’ panels which have
been coated with a special enamel that partly cleans itself.
This does not stop all marks on the lining, but helps to reduce
the amount of manual cleaning needed.
These panels work better above 200°C. If you do most of your
cooking below this temperature, occasionally remove the
panels and wipe with a lint free cloth and hot soapy water.
The panels should then be dried and replaced and the oven
heated at 200°C for about one hour. This will ensure that the
panels are working effectively.
