55
English
17. To Change Oven Door Seal
Open oven door. The seal is held in place by small hooks on
the rear face. At the corner pull seal diagonally away from
the door centre until that hook is released. Proceed to the
next hook and release it in a similar way, and so on. Use
force if the hooks are stiff , as the old seal will be discarded.
When fi tting new seal, position the seal join at the bottom.
Hook the new seal in one of the corner holes of the door,
and proceed round the door snapping in each hook in turn.
18. To Change Tall Oven Door Outer Panel
Remove oven door see 16. Lay door face down on a suitable
surface and remove 2 screws from bottom edge of door and
2 screws from inside face of door.
Remove outer door panel. Remove door handle by
unscrewing 2 screws. Remove 2 cross-headed screws
holding door handle fi xing bracket to door panel. Fit door
handle bracket and door handle to new panel.
Fit panel to door. Reassemble in reverse order.
19. To Change Tall Oven Door Magnetic Latch
Remove the control panel (see 4).
Remove the plinth (3 screws) and the central vertical cover
(5 screws). Prize the retaining clip off the magnet unit. Fit
new unit and retaining clip.
Reassemble in reverse order.
Check correct door operation.
20. To Remove Grill Element.
Disconnect from electricity supply.
Remove grill pan from grill chamber. From inside grill
compartment remove enamelled front shield from grill
roof, 2 screws and washers. Remove 2 screws and washers
securing the grill element front support. Remove the screws
from the grill elements.
Lift elements out carefully, disconnect the leads from the
element terminals noting their position. If it is not possible
to disconnect the leads in this way, pull cooker forward to
gain access to the rear, remove screws securing the electric
cover to the back sheet and remove cover and disconnect
the terminals from the rear.
Fit new elements, reassemble in reverse order. Check
operation of grill.
21. To Remove Oven Inner Back.
Open the oven door and remove the screws and washers
securing the inner back to the back of the oven.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the 4 screws and washers are fully
tightened.
22. To Change Fan in Oven.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Disconnect the 3 terminals connected to the
fan noting their position. Remove oven inner back (see 20).
Hold the fan blade and remove the centre nut (left hand
thread) 2 brass washers, fan blade and Circlip. Unscrew fan
retaining nuts and washers (3 off each) and lift the fan away
from the rear of the cooker. Fit new fan and reassemble in
reverse order. Check operation of oven.
23 To Remove an Oven element Thermal Cut-Out.
Disconnect from the electricity supply.
Pull the cooker for ward to gain access to the cover box.
Undo the cover screws and lift clear. The cutout is located
on the earth plate be side the oven element con nec tions.
Disconnect the cutout wir ing. Undo the fi xings that secure
the cutout to the earth plate and re move. Fit re place ment
control and re-as sem ble in reverse order.
