Falcon 1092 CKR, Руководство пользователя и инструкции по установке

Страница: 30 / 36

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
26
Check the ‘Technical Data’ section at the back of the book
that the hob is convertible to the gas you want to use.
A suitably competent person must perform the conversion.
After conversion the installation must comply with the
relevant regulations and also the local electricity supply
company requirements. Read the instructions before
converting this appliance.
n n
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and lead
to prosecution.
When servicing or replacing gas-carrying components
disconnect from the gas supply before starting operation.
Check the appliance is gas sound after completion.
DO NOT use reconditioned or unauthorised gas controls.
n n
Disconnect from the electricity supply before
servicing. Before electrical reconnection, check that
the appliance is electrically safe.
Injectors
Remove the pan supports and burner heads. Undo the large
brass nut on the top of the brass venturis and remove
(Fig.8-1)
.
Removing the Jets
First remove the service plate.
Either:
Use a long box spanner to access and remove the old
jets;
Or:
Lift up the front of the hotplate top and prop it up to
access the burner bases. Remove the old jets.
Save the jets removed from the appliance for possible future
use. Fit the new jets: see
Table 8-1
for the correct type.
* This is a special non-counterbored jet: it is NOT the same as
the 95 jet as used in the right-hand front natural gas burner.
Note: If you have lifted up the hotplate then carefully
replace it taking care not to damage or displace the ignition
electrodes or flame safety probes (Fig.8-2) and replace the
rear fixing screws.
Tap Adjustment
Pull off all the control knobs. Open the grill door and right-
hand oven door and remove the fixing screws underneath
the control panel. Remove the 3 fixing screws at the top of
the control panel.
Pull the control panel forward. Taking care not to damage it,
by protecting it with cloth for example, rest it on the open
grill door and oven door.
Turn the bypass screw on each control clockwise until it stops
(Fig.8-3) .
Refit the control panel and control knobs.
8. Conversion to LP Gas
Burner head
Burner base
Brass venturi
Fig.8-1
Natural Gas Propane Gas
Centre burner
133 95*
Large burners
120 40
Right front burner
95 32
Table 8-1
Fig.8-2
ArtNo.0102-0011 - Screwing
the control valve bypass screw
Fig.8-3