Falcon Magnetic Rotabroach CM/405/1, Руководство оператора

Страница: 7 / 16

Issue 3 Original Version JUNE 2014
7
5) SPEED SELECTION
The machine is equipped with gear ranges which can produce speeds up to 450rpm. Do not
change the gear while the motor is in motion.
The speed range for this gear is changed by the rotary change switch located on the gearbox
side.
The speed controller is adjusted by rotating the blue disk located on the control panel of the
motor.
Before cutting holes in the work piece ensure that you are using the correct speed and gear
for your material and cutter. Site conditions, e.g. diameter and condition of cutter, material
condition, material thickness, etc must also be taken into account when determining the
suitable cutting speed. The speed and feed rate must continuously be monitored and
adjusted to ensure optimum cutting conditions prevail.
In general the faster output speeds would be used for smaller cutters and the slower more
torque gears for larger cutters.
Gear selector in Position for small cutters
Gear selector in Position for large cutters
6) ARBOR ATTACHMENTS
The CM/405 has been design so that a number of 2 morse taper attachments can be used with this
machine.
Arbors for cutters
Currently available from Rotabroach™ are a number of various Arbors for fitting our range of cutters
that are available with the standard 19.05mm Weldon shank attachment and also are available with
a 32mm Weldon shank.
Twist drills
It is possible to also use twist drills with this machine. These can either be 2MT twist drills or a using a
suitable drill chuck. Please contact our sale department for further details. Max size twist drill that
can be used with this machine is 23mm.
Tap and Tap holders
Again as with the Twist drills this machine can also allow you to tap through holes. Using a suitable
tap or tap holder they can be connected to the 2MT output shaft.
The machine is suitable for tapping up to M20. Please contact our sales department for further
details and our available products.
Gear Selection