TANGO55/i & TANGO56/i User's Manual
Version 1.05
8 HOW TO UPDATE THE NEW FIRMWARE INTO THE
TANGO55/56 MODEMS
In order to allow users of TANGO55/56 to utilize newly released firmware, a program
has to be available to update the on-board Flash-Memory. The update program
with the new firmware will be distributed electronically via Internet or CD.
The update procedure of a new firmware erases the whole internal
flash memory and the pre-settings stored on it will be absolutely erased,
too.
In order to update a new TANGO55/56 firmware, please, follow step-by-step
the
instructions described below:
•
Point your web browser to
www.falcom.de
, go to
support
drivers &
firmware
TANGO55
or
TANGO56
and download the “
wswup_mc55_x.exe
“
or
wswup_mc56_x.exe
Update program, respectively.
•
Connect the serial port of the TANGO55/56 to one of the available COM ports
on your PC (e.g. COM1).
•
If TANGO55/56 is still powered on power it down. Make sure that the V+ and
IGN lines are disconnected from the external power source.
•
Start “
wswup_mc55_01.06.exe
” Update program. The Dialog Window shown
below appears.
•
Please, refer to the figure above for the following points. Select the Skip radio
button near the Pre-Check progress bar.
•
Click on the “Serial Config” button, and in the “Com” settings box select the
COM port where your TANGO55/56 is connected (i.e COM1) and in the
“Baud” settings box select the Baud rate to 115200.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 43 of 46
