FALCOM JP7-T Series, Описание аппаратуры

Страница: 37 / 50

GPS-RECEIVER JP7-T VERSION 1.02
7.2.1 NMEA output messages
Table 9 lists all NMEA output messages supported by SiRFstarIIe
evaluation receiver and a brief description.
Option Description
GGA Time, position and fix type data.
GLL Latitude, longitude, UTC time of position fix and status.
GSA GPS receiver operating mode, satellites used in the position solution and
DOP values.
GSV The number of GPS satellites in view satellite ID numbers, elevation,
azimuth and SNR values.
MSS (This message can be switched on via SiRFdemo software) Signal-to-noise
ratio, signal strength, frequency and bit rate from a radio-beacon receiver.
RMC Time, date, position, course and speed data.
VTG Course and speed information relative to the ground.
Table 9:
NMEA Output Messages
7.2.2
NMEA input messages
Message MID
1
Description
Set Serial Port 100 Set PORT A parameters and protocol
Navigation Initialization 101 Parameters required for start using X/Y/Z
2
Set DGPS Port 102 Set PORT B parameters for DGPS input
Query/Rate Control 103 Query standard NMEA message and/or set
output rate
LLA Navigation Initialization 104 Parameters required for start using
Lat/Lon/Alt
3
Development Data On/Off 105 Development Data messages On/Off
MSK Receiver Interface MSK Command message to a MSK radio-beacon
receiver.
Table 10: NMEA Input Messages
1. Message Identification (MID).
2. Input co-ordinates must be WGS84.
3. Input co-ordinates must be WGS84.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 37