BOLERO40 Series Promotion Kit
Version 1.0.1
This confidential document is a property of FALCOM GmbH and may not be copied or circulated without previous permission.
Page 17 of 21
Functions
Configuration alarms and their descriptions.
into the GPRS network. This setting is provider-dependant.
$PFAL,CNF.Set,GPRS.APN=Public4.m2minternet.com
APN (Access Point Name) name that your network operator has provided to you to connect the device to
the GPRS/Internet. This setting is operator or provider dependant.
$PFAL,CNF.Set,GPRS.AUTOSTART=1
Enables automatic attachments to the GPRS network. If the GPRS network connection gets lost, it tries to
reconnect automatically as soon as the network is available again.
$PFAL,CNF.Set,GPRS.DIAL=ATD*99***1#
The V.250 'D' (Dial) command causes the device to enter the V.250 online data state.
$PFAL,CNF.Set,GPRS.QOS=0,0,0,0,0
Quality of Service Profile used when the device sends an Activate PDP Context Request message to the
GPRS network.
$PFAL,CNF.Set,GPRS.QOSMIN=0,0,0,0,0
Minimum acceptable profile checked by the device against the negotiated profile returned in the
Activate PDP Context Accept message.
$PFAL,CNF.Set,GPRS.TIMEOUT=1,600000
Detaches the device from GPRS network if no TCP communication available within the timeout.
$PFAL,CNF.Set,GSM.BALANCE.DIAL=*100#
GSM dial number for retrieving balance information
$PFAL,CNF.Set,GSM.OPLOST.RESTART=1,1200000,8
Reinitializes the GSM engine periodically until a GSM operator is found.
$PFAL,CNF.Set,PROT.3DP=0
3DP protocol (
motion sensor data
) is deactivated. To activate this protocol replace 0 to 1 and send it to
the device.
$PFAL,CNF.Set,PROT.AREA=0
AREA protocol (
area states
) is deactivated. To activate this protocol replace 0 to 1 and send it to the
device.
$PFAL,CNF.Set,PROT.BIN=0
BIN protocol (FALCOM) is deactivated. To activate this protocol replace 0 to 1 and send it to the device.
$PFAL,CNF.Set,PROT.GGA=1
GGA protocol is activated. To deactivate this protocol replace 1 to 0 and send it to the device.
$PFAL,CNF.Set,PROT.GLL=1
GLL protocol is activated. To deactivate this protocol replace 1 to 0 and send it to the device.
$PFAL,CNF.Set,PROT.GSA=1
GSA protocol is activated. To deactivate this protocol replace 1 to 0 and send it to the device.
$PFAL,CNF.Set,PROT.GSM=1
GSM protocol is activated. To deactivate this protocol replace 1 to 0 and send it to the device.
$PFAL,CNF.Set,PROT.GSV=1
GSV protocol is activated. To deactivate this protocol replace 1 to 0 and send it to the device.
$PFAL,CNF.Set,PROT.IOP=1
