Falco AR-60-CGS, Инструкция по установке и эксплуатации

Страница: 8 / 20

2. Drill 2 x 8mm holes to accommodate the Plate II. Screw and tighten
the plate II onto the wall with the two screws provided. Fit the
chimney section on top of the extractor and fix it in place with the
screws.
Fitting the Chimneys for a Chimney Extractor:
Slide the top chimney piece (this is the one with the vents holes cut
into the sides) into the bottom section (this one is solid with no vent
holes).
1. Adjust the total chimney length, by sliding the two chimney sections to
the required length.
Plug
Plate II
Screw (4mm x
8mm)
Screw (4mm x
30mm)
8