fakro ZWMP, Инструкция по программированию и использованию

Страница: 5 / 16

4 Module programming
In order to operate electric FAKRO accessories equipped with the Z-WAVE system by means of
the ZWMP weather module, it is necessary to:
1. Add the device to be operated by means of the module to the “Z-Wave” system – see ZWP15 remote
control and ZWK15, ZWK1 keyboards manuals, chapter “Adding device to the network (INCLUDE
function)” or other controller working in the Z-Wave system. If the device is already operated with one
of the controllers, proceed to section 2.
2. Add the weather module to the Z-Wave network as a SECONDARY controller, chapter 4.1 (LEARN
MODE function).
and
3. Associate the device with a selected channel in the module (No. 2, Figure 1 ) specifying the task to be
performed by it (chapter 4.2, ASSOCIATE function): “O” - open, raise blind, “C” - close, lower blind.
Caution!!!
Every device physically removed from the network (e.g. in case of damaged) needs to be deleted
from the network (Sec. 4.6.2) so as to ensure the optimum communication between devices. Disconnecting a
device without deleting it from the controllers' memory will result in prolonged reaction time to the commands
sent and accelerated running down the batteries of the controller. If it becomes necessary to remove a damaged
device whose deleting from the memory is impossible, it is advisable to reconfigure the whole network (all
devices). When relocating a device within the network (e.g. socket module) it is recommended to delete it first
from the network and then, after installing it in a new work place, repeat adding procedure.
11.09.21 NC815 5/16 ©2011, FAKRO