Fakir VEYRON 2400, Руководство по эксплуатации

Страница: 17 / 48

17
VEYRON GB
• Press the foot button "On/Off" to switch off the
vacuum cleaner.
• Remove the plug from the mains socket.
• Press the foot button "cable rewind” to reel in
the cable.
Gently guide the cable with your hand until the
cable has been completely wound.
Filter changing and dust container cleaning
When the dust container or filters are full or if the
accessories are blocked (hose, pipe, nozzle)
suction performance will decrease. In this case,
clean the dust container or blocked filter or
remedy the blockage.
(Pls see page 20 Troubleshooting)
1- Spilling rubbish from the dust compart-
ment subassembly
Always operate the cleaner with the dust
compartment subassembly whole installed.
The dust container must be emptied if the
window of the filter indicator turns fully red when
the cleaner is operating at maximum power and
the nozzle is raised from the floor.
1. After removing the flexible tube, handhold
handle and press the locking button.
2. Take out the dustcup.
3. Take the dustcup lip off.
4. Carry away the dust-glass cap and Spill
rubbish
5. Clean the dirt from deep inside and replace it.
6. Close the lid and replace the dust compart-
ment subassembly until it is locked.
After Use
1 3
1 2
3 4
ATTENTION!
If you leave your work area, switch off
the appliance.
NOTICE!
The cylinder vacuum cleaner has an
overheating protection device. It will
switch off automatically if overheated (e.
g. due to blocked nozzles or overfull dust
container). If this happens, then turn off
the Appliance and remove the plug.
Remove the cause of overheating. Wait
approx. 45 min. You can use the cylinder
vacuum cleaner again once it has cooled
down.
WARNING!
Follow the steps below as soon as you
stop vacuum cleaning. Never leave the
appliance unattended.
NOTICE!
Only use original Fakir filters.
This is the only way to ensure that the
excellent filter properties of the vacuum
cleaner are utilised.