Usage of your rechargeable vacuum cleaner
Press the On/Off button to switch the appliance on.
Press one more time the On/Off button to switch the
appliance off.
ON / OFF press button
Usage of the nozzles
Crevice tool is for cleaning hard-to-reach places.
Carpet brush is for cleaning delicate surfaces.
Crevice tool
Carpet brush
During operation:
If the appliance is full charged,
the charging light will be green. If the battery level is
below %20, the indicator light will be flashing green as
a warning.
If the battery level is too low, then
the indicator light will be flashing
red regularly.
During charging:
When
charging; the indicator light will
be red. If the appliance is charged
completely, then the indicator light
will be green.
Charging indicator light
Empting the dust container
The performance of the cleaner is dependent on the
condition of the dust container and the filter. The dust
container should be emptied and cleaned regularly.
Make sure that both the dust container and filter are dry
before refitting them to the cleaner.
To empty the dust container, press and hold on the
container release button and pull the dust container
away from the unit.
Empty and clean the dust container.
Remove the Primary filter, HEPA filter and then shake
for cleaning. If the filter is very dirty, rinse it in warm
water.
Make sure the filters is dry before replacing it.
Replace the filters and refit into the dust container
before switching on and using the cleaner.
•
•
•
•
•
Press and hold
HEPA (High Efficiency Particulate Arresting) Filter will
stop 95 % of the particles as small as 0.3 microns that
approaches total efficiency on all known organisms
harmful to human.
Dust container
Primary filter
H.E.P.A filter
H.E.P.A filter
holder
Cleaning the dust filter and dust container:
Check that the vacuum cleaner is switched off.
Hold the vacuum cleaner with the nozzle pointing
downwards.
Press the release button; dismantle the filters from the
dust container.
Empty the dust container.
If necessary, wash the filter in lukewarm soapy water,
rinsing thoroughly afterwards.
Make sure that the filter is completely dry before
reinserting it in position.
Don’t forget to reinsert all the filters in position after
removing it for cleaning.
Damaged or very dirty filter should be replaced.
Cleaning and maintenance of the appliance
•
•
•
•
•
•
•
•
07
