HK 2200
EN
17
Remote control
Slide off the battery cover and insert 2 x AAA-size batteries with correct polarity, then
replace the battery cover.
Overheat Protection
This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat, e.g. due to the total or partial obstruction of the
grids. In this case, unplug the appliance, wait about 30 minutes for it to cool and
remove the object which is obstructing the grids. Then switch it back on as described
above. The appliance should operate normally. Should the problem persist, please
contact the nearest customer service.
Tip-over Protection
This heater is protected with a safety switch that turns off the appliance automatically
when the heater falls over, or is at an excessive angle from the horizontal. This helps
prevent accidents, and the heater will resume operation when it is put back upright.
Maintenance
When your heater needs cleaning, wipe exterior surfaces of the heater with a
moistened cloth. Not rinse with water directly. Be sure to unplug before cleaning.
Pull
out filters and clean them, when it’s very dirty.
To prolong the heater life, not disassemble it personally when malfunction occurs.
Send your heater to relative identification after-sold service center or provider for the
convenience inspecting.
NOTE!
The remote control buttons perform the same functions
as those on the control panel on the unit.