22
USAGE
GB
1. Separate the back part of the charging station from the
front part by pushing it downward.
(Fig. 1)
2. Find a suitable location on an indoor wall, near an
electrical outlet. Bear in mind the warnings described
above.
3. Hold the back part on the wall as shown in Fig. 2, mark
the position of the mounting screws and then drill the
holes for the screws.
4. Use the included anchors and screws to mount the
charging station. Insert the anchors in the holes and then
screw the screws into the anchors to a clearance of about
3 mm to the wall. Now hang the back part on the screws
and tighten the screws. Then connect the front part with
the back part.
5. Plug the small plug of the charger into the left jack on
the charging station. (Fig. 3)
If you wish to charge the battery with the automobile
charging cable using the socket of a car, caravan or boat,
make sure that the voltage is set to 12V. Then plug the
small plug of the vehicle charging cable into the right jack
on the charging station. (Fig. 4)
WARNING!
Before drilling the holes, make sure that no electrical
wires or pipes will be damaged.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
