5. Cinch the top tight from the back
Your enclosure hangs from a top strap that encircles the top of the four car
roof posts. When this top strap is tight your enclosure will stay up and be
secure.
At the top and back of the enclosure is a fabric flap covering a cam buckle and a ratchet
buckle to tighten the top strap. Open the flap and locate the strap exiting from the cam
buckle on the right side. Holding the back of the enclosure up toward the roof, tighten this
strap until the enclosure is held up along the top of your car just along the roof line.
Now tighten the top strap further with the ratchet buckle at the left. To tighten, lift the
ratchet lever up to the left. Each time you move the lever the ratchet will tighten the strap
one “click”.
If you run out of room on the ratchet, loosen the ratchet buckle by pressing the
black button in the center of the lever and loosen the ratchet to the first
“click”. Then retighten the cam buckle and following that the ratchet buckle.
When the enclosure is straight on the sides over the doors and there is no sagging, close
the ratchet lever and cover the buckles with the protective flap.
6. Attach the enclosure to the wheel wells and bumper.
Remove from the bag cpmtaining teh strap and rip-and-grip the four 1” x 8” pieces of
adhesive backed hook material.
Near each wheel cutout toward teh bottom you wil fina a strip of loop material sewn to the
inside of your enclosure. Note where the loop on the enclosure contacts the car, mate the
hook strip to the loop stirp on the enclosure and press the strip on the car in the noted
spot.
Next, find the hooks on the inside of the enclosure near the top of the rear wheel well.
Secure the hooked straps on each rear wheel well.
Keep your face and eyes clear of the hook and straps when you connect them. The elastic
strap can snap back if the hook fails to connect.
7. Attach the bottom hooks to the sides of your car.
Attached to the inside of the cover, near the bottom on either side are two hooks for at-
taching the cover to the bottom of the golf car. Each hook is attached to the cover by an
elastic strap. Grasp each hook and stretch to attach to the bottom edge of the golf car.
Keep you face and eyes cela of the hook and straps when you connect tehm.
The elastic strap can snap back if the hook fails to connect.
72042 (page 5 of 7)
12.18.09
