5
Issue 0-Feb 11
ENGINE TURNS OVER BUT WILL NOT START
Check:
Ignition switch is on (position 1)
Fuel tap is on
There is fuel in tank
Engine oil level is correct
The choke is in correct position (closed if engine is cold, open of engine
is hot).
If engine still does not start refer to engine manufacturer’s handbook.
ENGINE WILL NOT TURNOVER
If the eng
ine will not turn over refer to the engine manufacturer’s handbook.
POOR TOOL PERFORMANCE
Check that the motor speed is as specified in this manual.
Check the connection between the Drive Unit and tool.
Tool fault
– check tool handbook.
ENGINE STOPS SUDDENLY
Check fuel level in tank.
Check oil level.
Routine Servicing
7.1 Engine:
Refer to engine manufacturer’s handbook.
7.2 Drive Unit:
Before Starting:
Check engine oil level.
At End of Shift:
Clean the machine using water and/or steam.
Check for oil leaks.
General Maintenance
To ensure continued reliability, servicing should only by carried out by a skilled fitter.
The following general precautions must be observed when servicing equipment:
All parts should be laid out on a clean resilient surface. Special attention should
be paid to the identification of parts and their dismantling sequence.
The safety management of the company where the work is being carried out must
approve all solvent cleaners in use. The COSHH regulations must be read and
understood.
6. FAULT DIAGNOSIS
7. SERVICE AND MAINTENANCE