Greenlee Textron / Subsidiary of Textron Inc.
4
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
Chain Saws with Chain Brake
Procedure for connecting or disconnecting hydraulic
hoses, fittings or components:
1.
Move the flow lever on the power source to the
OFF position.
2.
Stop the hydraulic power source.
3.
Follow the sequence under Hose Connections
to prevent pressure buildup. In case some
pressure has built up, loosen hoses, fittings or
components slowly.
Do not disconnect tool, hoses or fittings while the
power source is running or if the hydraulic fluid is
hot. Hot hydraulic fluid can cause serious burns.
Do not reverse hydraulic flow. Operation with
hydraulic flow reversed can cause tool malfunction.
Connect the supply (pressure) hose and return
(tank) hose to the proper ports.
Hydraulic oil can cause skin irritation.
• Handle the tool and hoses with care to prevent
skin contact with hydraulic oil.
• In case of accidental skin contact with hydraulic
oil, wash the affected area immediately to
remove the oil.
Failure to observe these precautions can result in
injury.
Do not exceed the maximum hydraulic flow,
pressure relief or back pressure listed in the
Specifications and Parts manual.
Failure to observe this warning can result in
severe injury or death.
Do not change accessories, inspect, adjust or
clean tool when it is connected to a power source.
Accidental start-up can result in serious injury.
Failure to observe this warning can result in severe
injury or death.
Note: Keep decals clean and legible. Replace when
necessary — see the decals listed in the Parts and
Specifications manual.
Tool, chain, and other components
may be hot during and after opera-
tion. Allow to cool before handling,
or handle with heat-resistant gloves.
Failure to observe this warning
could result in severe injury.
IMPORTANT SAFETY INFORMATION
