Fagor FMD-49, Руководство по установке, использованию и обслуживанию

Страница: 17 / 26

www.fagorcommercial.com Page 17
MERCHANDSERS OPERATION AND SERVICE MANUAL/ Rev. JUN. 2015
If you keep the Condenser clean, you will minimize your service expense and lower your electrical
costs. Failure to maintenance clean condenser coil can initially cause high temperatures and
excessive run times. Continuous operation with dirty or clogged condenser coils can result in
compress or failures. This will not be covered under warranty.
Neglecting the condenser coil cleaning procedures WILL VOID YOUR WARRANTY.
To put back the condensing unit, slide in the unit carefully in. BE SURE TH E DRAIN PIPEIS LOCATED
OVER THE DRAIN PAN. Replace front bottom panel.
6.2 GASKET
Gaskets require regular cleaning to prevent mold and mildew build up and to keep the elasticity of
the gasket. Gasket cleaning can be done with the use of warm soap and water. Avoid the use of
chemical cleaning products on gaskets as this can cause them to become brittle and prevent
proper sealing. Also, never uses hard tools or knives to scrape or clean the gasket which could
possibly tear the gasket and rip the bellows.
Gaskets can easily be replaced and do not require the use of tools or authorized service personnel.
To remove the gasket, pull the gasket towards you. To replace gasket, press the gasket against the
groove of the door the gasket will “snap” back into place.
6.3 DOORS/HINGES
During transportation the doors hinges may become loose. If the door(s) don’t look aligned, tighten
the screws that hold the hinge brackets to the frame of the unit. If the doors are loose or sagging,
this can cause the hinge to pull out of the frame which may damage the doors and the door
hinges. In some cases, this fix or adjustment may require a qualified service agent or maintenance
personnel.
6.4 DRAIN
Each unit comes equipped with a drain pan located outside the unit. The drain pan catches the
condensation produced inside the evaporator coil. If the drain hose become loose or disconnected
from moving or bumping the unit, you may find a puddle of water inside/outside of the unit.
Replace or fix any lose connections. IF YOU NOTICE EXCESSIVE WATER ACCUMULATION ON THE
INSIDE OF THE UNIT, be sure the drain tube is connected firmly and not kinked or bent. It is the
owner’s responsibility to maintain the drain pan leveled, and with the drain hose inside of the pan.