Fagor FIC-381E, Инструкция по установке и эксплуатации

Страница: 46 / 80

46
3. INSTALLATION
FEATURES OF THE APPLIANCE
- This appliance is designed to operate correctly at room temperature according to its climate classification, which
is stated on the features plate located on the back of the appliance.
LOCATION
- The appliance must be installed on a flat, stable surface.
- When placing the appliance into the unit space, take care not to squash the mains cable. It is advis-
able not to use extensions or adaptors for connecting to the mains.
- Between the rear of the appliance and the wall, there must be a minimum distance of 20 mm and,
between possible future units hanging on the wall, a distance of 100 mm.
- Do not place any household electrical appliance which gives off heat on the appliance, such as:
ovens, microwaves, toasters, etc.
- If it is installed fully integrated, check that the aeration section in the kitchen unit is 200 cm
3 and that the venti-
lation channel at the rear of the unit has a minimum depth of 50 mm. Please follow the instructions relating to the
integration (Section 1).
- Check that there are no electrical appliances or components near the aeration openings.
Attention:
Access to the mains must be ensured to help with unplugging when required. If this is not possible, connect the
appliance to the mains by means of a double-break switch with an opening distance for the contacts of at least 3
mm, situated in an accessible place.
ELECTRICAL CONNECTION
- The appliance must be earthed in accordance with the law. The manufacturer cannot be held
liable for any incidents caused by failure to comply with this.
- Make sure that the voltage stated on the appliance’s features plate, located inside on the left-
hand side, corresponds to the voltage for the wiring in the house.
- Do not use adaptors or extensions.
- Prevent the cable from coming into contact with the motor.
- Prevent the cable from being trapped under the appliance.
BEFORE CONNECTING YOUR APPLIANCE
When the appliance is fully installed, the following is recommended:
- Clean the inside with warm water and bicarbonate of soda. Rinse and dry carefully.
- Wait 2 hours before starting up to ensure the stabilisation of the motor lubricants.
- Plug into the mains.
CLIMATE CLASSIFICATION ROOM TEMPERATURE
SN +10°C a +32°C
N +16°C a +32°C
ST +18°C a +38°C
T +18°C a +43°C