WARNING: Never touch hot soleplate at any time before cooling down!
Steam ironing
1. Put the unit base on a stable and level surface.
2. Grasp the water tank’s handle to remove the water tank, then fill it with water
through the filling aperture. You had better use purified water with less calcium
particles. After it, replace the water tank properly. The max capacity of water tank is
1.7L, the water level shall not be exceeded the MAX mark.
3. Put the iron on the thermal insulation stand of unit base.
4. Connect the appliance with power source, press down the power button, and the
defaulted low steam rate indicator will blink. And there are three modes including low,
medium and high steam rate available, you can select the desired steam rate for
each garment according to your requirement. Make sure that there is enough water
in the tank.
5. Turn temperature dial to your desired setting, which is depended on the fabric of
garment. The iron starts heating, and the temperature indicator will illuminate solidly
during heating. Refer to
“IRONING TIPS”
and
“ADDITIONAL TABLE”
as below
when select temperature.
6. After a few minutes, the temperature indicator will extinguish, it indicates the
soleplate temperature has achieved the selected temperature. When the indicator
of selected steam rate changes from flashing to illuminating, it indicates that the
iron is ready for ironing garment with steam.
7. Press the steam trigger with a little force, the steam will be sprayed from the
soleplate continuously, and then you can iron the garment with steam.
8. Quickly press the steam trigger twice to produce shot of steam if you need to
remove hard crease. The “Shot of steam” function can be only activated under
medium steam rate and high steam rate.
Note: There may be dripping water during spraying steam when the
temperature of the soleplate is at and lower than the second setting. This is
normal.
30
