40i P - Installation/Operation - DRO operation - (15/32)
Consists of a top view and two sections with a mobile partition
by pressing the arrow keys.
The 3D graphic may be rotated using the arrow keys.
Opens the window for entering the actual (real) part
dimensions. Viewing the simulation in real mode requires
entering the real X, Y, Z dimensions of the part.
2.5.4.2
Cycle execution:
Pressing the Run key, the DRO shows the distance the axes
must move to position at the first hole. Move the axes to zero. .
The status bar indicates the number of the current hole and the
total number of holes programmed in the cycle.
Once positioned at the drilling point, touch the surface with the
tool. Press the Z axis key. The Z axis display reads zero.
Press Enter. A window opens for entering the hole depth.
Press Enter to validate. The entered depth value is shown on
the Z axis display.
Move the Z axis until its display reads zero. This way, the hole
is drilled with the indicated depth.
Press this key to show the coordinates of the next drilling
position (hole).
Repeat these steps until all the holes of the circle are drilled.
2D views
View
Engineering Drawing
View
3D
3D solid
Size
Run
Current hole Nr.
Total number of holes programmed.
