Fagor 6H-750A, Инструкция по эксплуатации

Страница: 24 / 74

e n g l i s h
18
4
5
Troubleshooting
Safety
You can solve the following problems yourself:
4.1 4.1 The oven is not heating up. Check it is
plugged in and switched on and that the fuse
has not blown. Select a higher temperature
setting.
4.2 The interior light is not working. Change the
bulb or replace the fuse.
4.3 Smoke is coming out during cooking. Turn
the temperature down and/or clean the oven.
4.4 The pyrolysis cleaning process is not
being carried out. Ensure the door
is correctly closed. Locking system or
temperature sensor failure. Call the Technical
Service.
4.5 A beep is sounding. The selected
temperature setting has been reached. The
cooking cycle is complete.
4.6 The oven makes a noise after cooking.
This is normal, as the fan keeps running until
the temperature inside and outside the oven
is reduced.
4.7 Failure warnings.
Temperature sensor failure.
Do not try to repair the oven yourself. Call
the technical assistance service.
• The oven must be installed by an authorised
installer in accordance with the manufacturer’s
instructions and diagrams.
• The electrical installation must be dimensioned
for the maximum power indicated on the
reference plate and the electrical socket must
have a regulatory earth connection.
• The mains circuit supplying the oven must have
a single-pole cut-off switch with at least 3 mm
between contacts.
has been left after the cleaning processes.
Depending on the models, the side runners
are fi xed in two ways, either without a
support (3.3.1, 3.3.2) or with a support
(3.3.4, 3.3.5). When you have removed them,
use a damp cloth to clean the side walls
(3.3.3, 3.3.6). When you have cleaned the
oven walls, replace the runners. If your oven
has a fold-down grill, pull upwards and press
to fold it down (3.3.7) and clean the top wall
with a damp cloth (3.3.8).
3.4 Cleaning the glass.
Cleaning the outside of the glass: Use a
soft cloth soaked in a glass cleaning product.
Cleaning the inside of the glass: If the
inside of the glass is dirty, you can remove it
for cleaning.
When the oven has cooled down, open
the door as far as it will go (3.4.1) and fi x
it in place with the red stops supplied in
the accessory bag (3.4.2). Insert the two
remaining accessories so that they provide
leverage to lift up the glass (3.4.3). Remove
the glass (3.4.4), clean it and dry it with a
cloth (3.4.5). If necessary, remove the whole
glass panel unit inside the door. This unit
consists of either one or two glass panels,
depending on the model, with a black stop
in each corner. To remove them, place your
hand under the door and pull upwards
(3.4.6). When you have taken out the unit,
remove the stops to clean the glass panels
(3.4.7).
When the glass panels are clean (3.4.8) fi t
them onto the rubber stops again, with the
stud facing upwards (3.4.9) and replace the
glass panels so that the letters “L” (left) and
“R” (right) are beside the hinges (3.4.10).
Lastly, place the remaining glass panel so
that the word PYROLYTIC can be read
(3.4.11). Remove the stops (3.4.12) and
close the door.
Warnings:
• Make sure the oven is switched off.
• Allow the glass to cool down before
removing it.
• Never use steam cleaning machines.
3.5 Cleaning the outside of the oven. Use
neutral cleaning products. Dry the oven well
with a soft cloth.