Fagor 5CFB36BL, Инструкция по уходу и эксплуатации

Страница: 5 / 12

version, an air deflector is placed on the superior part of the pipe which allowing air to be
recirculated.
* In ventilation mode (Fig.2), fumes are directly vented outside, through an evacuation duct
connected with the superior part of the wall or the ceiling. Utilizing both the charcoal filter and air
deflector are not necessary in this case.
3. Installation
Before installing the appliance, make sure that no parts are damaged. In case of damaged parts,
contact your retailer and do not proceed with installation. Read all of the following instructions with
care before installing the appliance.
- Use an air outlet pipe of the shortest possible length.
- Limit the number of bends in the pipe.
- Use only materials approved by safety standards and regulations.
- Avoid sudden changes in pipe section (recommended diameter minimum: 6 inches (150 mm) or
equal surface area).
This hood has been designed in order to position the air outlet towards the upper rear side of the
appliance. In case you want to position the air outlet towards the rear side, it is necessary to
remove the no. 10 screws of the suctioning unit support (Fig.13), then take the suctioning unit out,
by rotating it in such a way to position the air outlet nozzle towards the rear side of the appliance
(Fig.13); then place the suctioning unit back into its position, and re-insert the previously removed
screws.
Wall Mounting:
Using the drilling jig supplied (dis. 3A). Drill the holes for the wall bracket installation (Fig.3B); the
hood must be positioned
at a minimum of 16 inches (40 cm)
from the cooktop. Mount the brackets
on the wall using the screws supplied and hang the hood.
4) on the bracket previously mounted. Using the adjustment screws (fig. 5) make sure
the hood is horizontally well aligned. Lift the front panel upwards, as shown in Fig. 6. Remove the
grease-filter.
In connection with the holes indicated by the arrows in Fig. 7a-7b, drill two 8 mm diameter holes
into the wall, and insert the screw anchors supplied with the appliance. Screw in the screws
supplied with the appliance, in order to further secure the appliance to the wall; place the grease
filter back into its seat and close the front panel.