Cooling time
Set “programme switch” (1) to the cooling position .
10 minutes will be shown on display (8) but this can be changed, up to 2 hours.
Keep “selection” button (7) pressed till the desired cooling time is reached. The
selected value continues to flash till confirmed by pressing “start” button (2), at which
point it goes fixed and an acoustic signal is emitted.
Time drying
Set “programme switch” (1) to the time position .
20 minutes will be shown on display (8) but this can be changed, up to 2 hours.
Keep “selection” button (7) pressed till the desired drying time is reached. The selected
value continues to flash till confirmed by pressing “start” button (2), at which point it
goes fixed and an acoustic signal is emitted.
GB
- 60 -
GB
PROGRAMMING
Protection against non-authorized use (machine lock)
When activated, this stops the user from changing any of the parameters.
To activate the function, press “start” button (2) for around 4/5 seconds. At the same
time an acoustic signal is emitted (short 1” beep).
Switching the machine off using “on-off” button (3) cancels the previous setting.
To cancel this function, press “start” button (2) again for around 4/5 seconds. At the
same time an acoustic signal is emitted (long 2” beep).
At the end of the cycle the machine lock function resets.
Menu symbols
Function
Menu values
Memory status
Delay time
From 0 to 19 hours
Resets
at end of cycle
Resets
at end of cycle
From 10 min. to 2 hours
Cooling time
Time drying
From 20 min. to 2 hours
Resets
at end of cycle
Resets
at end of cycle
Start on 4/5” lock
Start off 4/5” unlock
Machine lock
