3
5
0
420 (Ctrs)
400 (Ctrs)
800
7
7
5
2025
Ground
level
300x300x700mm
C20 concrete base
(recommended)
300
120
300
650
655
50
700
50
12
5
50
300x300x700mm
C20 concrete base
(recommended)
Ground level
M10 S/S
cap nut
M10 x 150mm
threaded rod
resin anchor
Installation Instructions
ALL INSTALLATION WORKS TO BE CARRIED OUT BY COMPETENT PERSONNEL - INSTALL AS COMPLETE UNIT
Tord Lounger
1. Install suitable foundation pads (see illustration) each with top face at ground level.
2. Attach base assembly to upper frame using the 4 no. M10 x 25mm csk bolts and locknuts - tighten to 14Nm.
3. Position lounger in correct orientation with base legs centrally on foundation pads; then mark hole positions
through base frame.
4. Remove the lounger; drill holes Ø12mm x 125mm deep or as per manufacturer’s recommendations.
5. Clear debris from holes.
6. Fill the holes to within approximately 35mm from the top with Hilti HY150 resin (or similar). Lift the lounger
(with threaded anchor rods/capnuts in place) and carefully lower the anchors into the holes, leave for two
hours before using.
7. Using a torque wrench, tighten nuts and washers anchoring base to 30Nm to fasten down the lounger.
8. Check level.
IMPORTANT NOTES:
Ensure that stainless steel is protected during site cutting of stone – contamination from disc cutters will
produce corrosion on stainless steel components.
4
TORD LOUNGER
installation