1
75
200mm x M10
threaded rod
anchor resin
fixed into Ø14mm
hole
M10
S/S
cap nut
5
0
2300 x 400 x 300mm
C20 Concrete Base
(recommended)
Ground level
400
400
2300
300
2110
750
450
Ground level
Foundation 2 no. pads 2300x400x300mm in
C20 concrete (recommendation only)
2610 (Fixing Ctrs)
2420 (Fixing Ctrs)
2500
420
(Fix Ctrs)
500
(Fix Ctrs)
420
(Fix Ctrs)
125
125
620
700
620
2690
2190
Installation Instructions
ALL INSTALLATION WORKS TO BE CARRIED OUT BY COMPETENT PERSONNEL - INSTALL AS COMPLETE UNIT
Setting out dimensions
Skop Outdoor Dining Set
(surface fix only)
1. Install suitable foundation pads (see illustration) each with top face at ground level
2. Position table and benches in correct orientation with bases centrally on foundation pads, then mark hole
positions through base section.
3. Remove the table and benches; drill holes Ø14mm x 175mm deep
4. Clear debris from holes.
5. Fill the holes to within approximately 35mm from the top with Hilti HY150 resin (or similar). Lift the table and
benches (with threaded anchor rods / capnuts in place) and carefully lower the anchors into the holes, leave
for two hours before using.
6. Using a torque wrench, tighten nuts and washers on to base frame to 30Nm to fasten down the table and
benches.
7. Check levels
IMPORTANT NOTE:
Ensure that stainless steel is protected during site cutting of stone – contamination from disc cutters will
produce corrosion on stainless steel components.
Typical Base Fixing Detail
5
SKOP (Dining Set) installation
