&
5HVSRQVLEOH
)RUHVW0DQDJHPHQW
Introduction
Design
Design, shop drawings and development by Factory Furniture Ltd.
Manufacture
Factory Furniture manufactured components. Products are assembled in Factory workshops, checked and
dispatched ready for installation. Replacement products or components thereof should be ordered direct from
Factory Furniture Ltd.
Copyright
The design copyright for the product and drawing copyright remains the sole property of Factory Furniture Ltd.
General Specifications
Table
Metric
length 2690mm | width 700mm | height 750mm
Imperial
length 8’ 10” | width 2’ 3” | height 2’ 5½”
Approx Weight
94kg
Fixing Centres
2610mm (8’ 7”) x 500mm (1’ 7½”)
The Skop table can be combined with a couple of Skop benches to create an outdoor dining set.
Detailed Material & Finish Specifications
Table Slats
• Manufactured from FSC
®
certified tropical hardwood or FSC certified oak
(other FSC timber
options available upon request)
• Profiled and left untreated as standard
(oil or microporous woodstain treatment available
on request)
• Supported on frame -
attached with 4 no. fixing points each
Frame
• Manufactured from stainless steel rectangular section tubing - satin polished or polyester powder coated
finish
(powder coat colour grey as standard or to customer specification)
• Anchored using 2 no. resin fixed M10 x 200mm threaded rods and cap nuts per base
(4 no. per table)
General Maintenance
(Recommended Schedule & Guidelines)
Daily/Weekly/Monthly
(or as adopted)
Visual checks of table top and frame - check all items for superficial or physical damage.
Three Monthly
Clean all items as detailed below check all fixings are seated correctly; inspect timber for serious damage and
splinters.
Six Monthly
Secure all fixings; full clean as detailed below; check that table is firmly secured to the ground
Specific Maintenance Details
FSC Timber
Clean with a stiff brush once per year, especially in more exposed locations, in order to prevent a verdigris type
build up on the timber surface. Ideally this should be completed in early spring. During the cleaning stage, all
exposed timber surfaces should be inspected for splits and splinters. Any splinters and graffiti should be
removed and the surface sanded with 100 grit sandpaper in order to remove any uneven / sharp edges or
surfaces.
During the first few months after installation the tannin naturally occurring in the timber may leach out and
cause a brown staining on the bases. This may be removed with a light solution of household bleach and
water.
Stainless Steel
(polished stainless steel only)
Clean as required, but at least every three months, using a stainless steel polish and a lint free cloth. To remove
ground in dirt, a stainless steel finishing pad may be required.
Polyester Powder Coated
For general cleaning using a damp cloth and warm soapy water only. Scourers and abrasive cleaners are NOT
suitable for this type of finish and may damage it. Before using any cleaning agents to remove graffiti etc. try
on a small, inconspicuous area first to avoid causing more unsightly damage.
2
SKOP TABLE specification
