www.factorelectronics.com [email protected]
Introduction
Congratulations and thank you for purchasing a Factor Electronics product. The Factor
Electronics VERSA-6.5 speaker system provides a high quality soultion for paging and
background music. The VERSA-6.5 can be hung from ceilings as a pendant style speaker
or mounted to any hard surface using the included swivel ball mount and used as a
projection speaker. The VERSA-6.5 is very easy to install and operate. Please read this
entire manual to get the most from your VERSA-6.5 speaker system.
Unpacking
The VERSA-6.5 includes the following parts:
1 x VERSA-6.5 speaker (white or black)
2 x Top finishing caps (one for pendant mounting and one for bracket mounting)
1 x 15' aircraft type hanging cable with connectors
1 x Bag containg screws and loop hanging bolt
1 x Ball/swivel mounting bracket
1 x VERSA-6.5 manual
Installation:
The VERSA-6.5 speakers can be used with constant voltage 25/70V amplifiers or 4/8ohm
stereo amplifiers. A wattage tap dial is provided on the back panel which provides the
following wattage taps: 30W, 15W, 8W, 4W 25Volt or 70Volt and a 8ohm transformer
bypass setting is also provided. Always make sure that the wattage of all speakers
combined does not exceed the wattage of the amplifier. Example: 10 x VERSA-6.5
speakers tapped at 15W/70V =150watts. Always add 30% headroom in amplifier power
150watts x 1.3= 195watts. If you are unsure how to connect your speakers contact
Factor Electronics tech support at
www.factorelectronics.com
or email to
. It's always best to plan out your system and wattage taps
before installation. Caution: connecting a 70V constant voltage amplifier to the VERSA-
6.5 speakers with the speaker set to 8ohms can damage both the amplifier and the
speaker. Take care to set the wattage taps properly before you hang or mount the
speakers.
Set the correct wattage
tap prior to installation
Speaker connection
push terminals
Wire channel
