Thank you for purchasing this product. For optimum performance and safety, please read
these instructions carefully before connecting, operating or adjusting this product. Please keep
this manual for future reference.
SURGE PROTECTION DEVICE RECOMMENDED
This product contains sensitive electrical components that may be damaged by electrical
spikes, surges, electric shock, lightning strikes, etc. Use of surge protection systems is highly
recommended in order to protect and extend the life of your equipment.
SAFTY AND NOTICE
1) The transmission distances of HDMI over UTP cables are measured using TE
CONNECTIVITY 1427071-6
2)
EIA/TIA-568-B termination for CAT cables is recommended for better performance.
3) DO NOT use 568A/568B standard mixed CAT cable (cross-over cables) because there
are 2 pairs swapped, this will make the POE OVER-CURRENT and damage the POE
components. Please use straight-through CAT 5/6 cable (both RJ45 headers are 568A or
568B standard).
4) It is recommended to power up the device after connection of sources, sink and CAT
cable.
5) To reduce the interference among the unshielded twisted pairs of wires in CAT cable, do
not run HDBaseT / Zone Cat5e/6/6a cabling with or in close parallel proximity to mains
power cables. Shielded CAT cables can be used to improve EMI problems, for long
transmission.
6) The quality of the CAT cables has the major effect on the transmission limit that can be
achieved and the picture quality, the actual transmission range is subject to the installers
choice of CAT cables.
7) Do not substitute or use any other Power Supply other than the enclosed unit, or a Factor
Electronics approved Replacement Part. Doing so will void the warranty and potentially
