Facebook Surround 360, Руководство пользователя

Страница: 50 / 68

How to Verify Camera Connections (Optional)
2.
Open FlyCapture (Point Grey capturing software)
FlyCapture 2 Camera Selection 2.9.3.43
Camera List (17 cameras detected) Camera Information
Auto Force IP
Serial #
15355848
15636785
15636826
15636828
15636829
15636830
15636831
15636832
15636834
Model
Grasshopper3 GS3-U3-41C6C
Grasshopper3 GS3-U3-41C6C
Grasshopper3 GS3-U3-41C6C
Grasshopper3 GS3-U3-41C6C
Grasshopper3 GS3-U3-41C6C
Grasshopper3 GS3-U3-41C6C
Grasshopper3 GS3-U3-41C6C
Grasshopper3 GS3-U3-41C6C
Grasshopper3 GS3-U3-41C6C
Interface
USB 3.0
USB 3.0
USB 3.0
USB 3.0
USB 3.0
USB 3.0
USB 3.0
USB 3.0
USB 3.0
Serial Number:
Model:
Vendor:
Sensor:
Resolution:
Interface:
Bus Speed:
IIDC Version:
Firmware Version:
Firware Build Time:
Driver 16130496
Grasshopper3 GS3-U3-41C6C
Point Grey Research
CMOSIS CMV4000 (1” Color CMOS)
2048x2048
USB 3.0
S5000
1.32
2.14.3.0
Tue Apr 21 18:51:25 2015
None
IP Address
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
| flycap
- Confirm all connections are USB 3.0 and total of 17 cameras detected
All cameras are pre-focused, but critical focus should be
checked before capturing. To check the focus of each lens,
open a live preview by double clicking on the camera.
Manually adjust the focus of the camera.
Optional : Check focus by clicking on individual camera
Tips
If a camera is not connected, or a camera says it is connected using USB 2.0, unplug cables from the breakout box
and re-seat them in different buses until all 17 cameras are connected as USB 3.0. Remember that each camera
must be alone in a USB 3.0 port pair in order to satisfy the requirement that there is only 1 camera per bus.
If this doesn't resolve the problem, try the following steps:
1. quit flycap
2. reset physical USB connections
3. run the following USB reset command:
Refresh OK Configure Selected Cancel
| /home/facebook1/vr_camera_hw/scripts/usbreset.sh
00
Make sure ALL 17 cameras
are recognized as USB 3.0
6