Face KBS1E, Инструкция по сборке

Страница: 10 / 12

D112 EN – 2021 05 01 10 www.facespa.it
4. SIDE WALLS BREAK-OUT SYSTEM
4.1 ASSEMBLY PROCEDURE FOR KBS1D KIT
Assemble the components in the kit KBS1D on the side wall as shown below.
The vertical size of the leaf are indicated in Fig. 5. The horizontal size of the leaf are indicated in Fig. 7.
Note: The KBS1D break-out kit is designed to be assembled on side walls provided with hinges for the break out.
Step Ref. Description
1 A Make 2 slots d.5x15mm, on the vertical profile of side wall for attaching the upper pin, as shown in Figure 8.
Insert the upper pin (A) in the vertical profile and secure using the supplied screws in the slots.
2 A Make 2 slots d.5x15mm, on the vertical profile of side wall for attaching the lower pin, as shown in Figure 8.
Insert the lower pin (A) in the vertical profile and secure using the supplied screws in the slots.
3 B Fix the upper bracket (B) to the top edge profile, at the upper pin (A), by screws not supplied by us.
4 B Fix the lower bracket (B) to the floor, at the lower pin (A), by screws not supplied by us.
5 C If necessary, fix protection (C) to the side wall, using the provided screws, respect the measurements shown
in Figure 8.
Note: the protections (C) avoid direct contact of the aluminium between the sliding leaf and the side wall,
when the sliding leaves and side walls are break out.
6 D If necessary, fix the hook brackets (D) to the side wall, using the provided screws, respect the measurements
shown in Figure 8.
4.2 INSTALLATION AND ADJUSTMENT PROCEDURE OF THE SIDE WALL
Step Ref. Description
1 - Make the installation of the frame system.
2 D Move the sliding doors in closed position. If necessary, fix the hook brackets (D) to the sliding leaves in
correspondence of the hook brackets (D) already fixed to the side wall, using provided screws.
Note: the hook brackets (D) are hooked between them, and they prevent the break-out of the side wall when
the door is closed.
3 A Adjust the release force of the upper pin (A) on the upper bracket (B), as shown in fig. 9.
4 A Adjust the release force of the lower pin (A) on the lower bracket (B), as shown in fig. 9.
5 - Make adjustments of sliding door indicated in the adjustment procedure, as illustrated in figure 2.
Note: verify that the required force to break-out every door does not exceed the value of 220N, as required
by the EN 16005 European standard.
6 - Fix the photocell PH3 on the perimeter profile at the top, through the KPH1D support, so that the break-out
of the leaf and side wall are detected by the photocell, as indicated in figure 7.
7 - Make the electrical connections of the PH3 photocell to the electronic control 5CB01, as shown in Figure 3.