D112 EN
–
2021 05 01
6
www.facespa.it
3.2 INSTALLATION AND ADJUSTMENT PROCEDURE OF THE BREAK-OUT MOBILE LEAF
Step
Ref. Description
1
H
Cut the sliding guide (H) to measure Lm (or higher), and attach it to the floor, as shown in the drawings of the
various types of door available in this manual, with screws not supplied by us.
2
K
Fix the leaf to the automation carriages, using at least 2 fixing screws, and add the second upper wheel (K) on
each carriage.
3
C
Adjust the pressure of the lower pin (C) on the sliding guide (H), as shown in fig. 2.
4
B1
To level any collapse of the break-out leaf, proceed as shown in fig. 2 and as indicated below:
- Loosen the B2 and B3 screws,
- Tighten the B1 screw until you get the levelling of leaf,
- Tighten the B2 and B3 screws.
5
F
Adjust the force necessary for the break-out of the leaf, as shown in fig. 2.
- To increase/reduce the manual force to break-out leaf, tighten/loosen the screw on the side of the coupling
pin (F);
- if you want to further reduce the manual force to break out leaf, you can increase the measurement of 150
mm to fixing the coupling pin (E) and (F).
Note: verify that the force required to break-out every door does not exceed the value of 220N, as required
by the EN 16005 European standard.
6
-
Fix the PH3 photocell on wall at the top, through the KPH1E support, so that the break-out of the leaf is
detected by the photocell, as indicated in Figure 6.
7
-
Make the electrical connections of the PH3 photocell to the electronic control 5CB01, as shown in Figure 3.
8
J
Apply on the leaf, in a visible location and in the direction of the break-out, the label supplied indicating the
emergency exit, as illustrated in Figure 2.
FIGURE 2: KBS1E adjustments
Содержание KBS1D
Страница 5: ...D112 EN 2021 05 01 5 www facespa it FIGURE 1 KBS1E assembly drawing...
Страница 8: ...D112 EN 2021 05 01 8 www facespa it FIGURE 6 KBS1E horizontal sizes...
Страница 9: ...D112 EN 2021 05 01 9 www facespa it FIGURE 7 KBS1D horizontal sizes...
Страница 11: ...D112 EN 2021 05 01 11 www facespa it FIGURE 8 KBS1D assembly drawing...