10
Parallel
Connections
While the mode selector switch is in the
Parallel
position the input connectors for
both channels are wired directly in parallel (Ch. A input will drive Ch. A & B output). The
output volumes can still be controlled individually by adjusting the front dials as in normal
operation
.
To use parallel mode follow these steps:
1. Turn off the amplifi er.
2. Toggle the mode selector switch to the “Parallel” position.
3. Attach speakers into the NL4 or binding post connectors,
(both A & B if desired).
4. Input signal into Ch. A or B, turn both front controls down.
5. Turn amplifi er on.
6. Slowly turn up Ch. A & B front controls until desired signal level is reached.
7. Check that amplifi er is running properly (not showing Clip /Fault LED’s).
Amplifi er
(Rear view)
≥2Ω
Mixer (Console)
Outputs
Inputs
L R
1 2
Monitors
≥2Ω
+
–
1
+
2
–
2
+
1
–
≥2Ω
Ch. A & B
