Fac S220 Pro, Инструкция по установке, эксплуатации и обслуживанию

Страница: 24 / 32

20
TROUBLESHOOTING AND REMEDIES
The table below indicates the most common problems that may arise during
slicing and the necessary remedies.
PROBLEM POSSIBLE CAUSE REMEDY
The machine does not start
when the green button is
pressed No power supply
The blade guard is not
correctly positioned.
Defective electrical control
circuit.
Ascertain that the plug is is
correctly inserted.
Check
Call technical assistance
The machine does not
start, and there is
continuous noise like a
buzz (only in the case of
machines equipped with
three-phase motors. The motor is running on
single-phase mode Press the red button
immediately and have the
power supply cord and the
circuits upstream verified
by qualified personnel.
When the green button is
pressed, the machine stats,
but the white functioning
light is not on. Defective indicator Do not use the machine
when the pilot lamp is not
on. Call technical
assistance
The machine starts, but
there are vibrations. The
motor is very hot and there
is a bad smell. Defective motor or
transmission. Do no use the machine.
Call technical assistance.
Under strain, the machine
slows down or comes to a
stop. Defective transmission Call technical assistance
Excessive resistance to
product slicing. The blade is blunt Sharpen the blade
The slices are ragged
and/or shaped irregularly The blade is blunt
The blade is excessively
worn out Sharpen the blade
Call technical assistance
Unsatisfactory blade
sharpening Worn wheels Replace the wheels. Call
technical assistance
The product trayu does not
slide Guides are insufficiently
lubricated Lubricate
When the red button is
pressed, the machine does
not stop Defective electrical control
circuit Stop the machine, unplug
from mains and call
technical assistance